2003 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Component Location
BJ At left rear floor partition panel. See Figure.
BK At left rear quarterpanel. See Figure.
BL At right rear floor partition panel. See Figure.
BM At right rear quarterpanel. See Figure.
EA (3.0L) At middle of right inner fender panel. See Figure.
EA (4.3L) At middle of right inner fender panel. See Figure.
EB (3.0L) At middle of left inner fender panel. See Figure.
EB (4.3L) At middle of left inner fender panel. See Figure.
EC (3.0L) At front of intake manifold. See Figure.
EC (4.3L) On right cylinder head. See Figure.
ED (3.0L) At rear of intake manifold. See Figure.
ED (4.3L) On left cylinder head. See Figure.
EE (3.0L) Under ABS & TRAC & VSC actuator. See Figure.
EE (4.3L) Under ABS & TRAC & VSC actuator. See Figure.
IF At left kick panel. See Figure.
IG At left side of dash. See Figure.
IH At right dash panel brace. See Figure.
II At right side of dash. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.