2003 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Fuel Lid: Components: Removal

  1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 
  2. REMOVE REAR FLOOR FINISH PLATE 
  3. REMOVE LUGGAGE COMPARTMENT TRIM FRONT COVER 
  4. REMOVE LUGGAGE COMPARTMENT TRIM SIDE COVER LH 
  5. REMOVE FUEL LID LOCK ASSEMBLY 
    1. Remove the nut, and remove the lamp failure relay, then disconnect the connector.
      Fig 1: Identifying Lamp Failure Relay
      G03598920Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the nut from the fuel lid side.
    3. Remove the nut and lock assembly, then disconnect the connector.
    Fig 2: Identifying Lock Assembly
    G03598921Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FUEL TANK CAP TETHER FROM FUEL FILLER OPENING LID 

    Remove the clip and fuel tank cap tether from the fuel filler opening lid.

  7. REMOVE FUEL TANK FILLER PIPE SHIELD 
    1. Remove the 4 screws.
    2. Remove the fuel tank cap and shield.
      CAUTION: Always keep the tank cap closed when it is not required to be open. Keep all fire away during the operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.