Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus GS 300FACTORY OEM SERVICE PROCEDURE
Service Data
WARNING: This page is about a different car, the 2005 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
SERVICE DATA
| Brake pedal height (from asphalt sheet) | 150.0 - 160.0 mm (5.906 - 6.299 in.) |
| Brake pedal freeplay | 0.2 - 2.0 mm (0.008 - 0.079 in.) |
| Brake pedal reserve distance at 490 N (50 kgf, 110.2 lbf) | More than 93 mm (3.66 in.) |
| Front brake pad thickness STD | 11.0 mm (0.433 in.) |
| Front brake pad thickness Minimum | 1.0 mm (0.039 in.) |
| Front brake disc thickness STD | 32.0 mm (1.260 in.) |
| Front brake disc thickness Minimum | 30.0 mm (1.181 in.) |
| Front brake disc runout Maximum | 0.05 mm (0.0020 in.) |
| Rear brake pad thickness STD | 10.5 mm (0.413 in.) |
| Rear brake pad thickness Minimum | 1.0 mm (0.039 in.) |
| Rear brake disc thickness STD | 12.0 mm (0.472 in.) |
| Rear brake disc thickness Minimum | 10.5 mm (0.413 in.) |
| Rear brake disc runout Maximum | 0.05 mm (0.0020 in.) |
| Rear brake disc inside diameter STD | 190 mm (7.48 in.) |
| Rear brake disc inside diameter Maximum | 191 mm (7.52 in.) |
| Parking brake shoe lining thickness for rear disc brake STD | 2.5 mm (0.098 in.) |
| Parking brake shoe lining thickness for rear disc brake Minimum | 1.0 mm (0.039 in.) |
| Parking brake pedal travel at 294 N (30 kgf, 66.1 lbf) | 7 - 9 clicks |
| Parking brake clearance between rear shoe and lever | Less than 0.35 mm (0.0138 in.) |
| Parking brake adjusting shim thickness for rear disc brake | 0.3 mm (0.012 in.) |
| Parking brake adjusting shim thickness for rear disc brake | 0.6 mm (0.024 in.) |
| Parking brake adjusting shim thickness for rear disc brake | 0.9 mm (0.035 in.) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
