2003 Lexus ES 300FACTORY OEM SERVICE PROCEDURE

How To Proceed With Troubleshooting

WARNING: This page is about a different car, the 2004 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Troubleshoot in accordance with the procedure on the following pages.

  1. VEHICLE BROUGHT TO WORKSHOP 
  2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK (See  CUSTOMER PROBLEM ANALYSIS CHECK  ) 
  3. PROBLEM SYMPTOMS TABLE (See  PROBLEM SYMPTOMS TABLE  ) 
    1. Without applicable symptoms, proceed to A.
    2. With applicable symptoms, proceed to B.
    1. B: Go to step   5 
    2. A: Go to next step 
  4. PERFORM TROUBLESHOOTING IN FOLLOWING METHOD, DEPENDING ON MALFUNCTION SYMPTOM 
    1. On-vehicle Inspection (See ON-VEHICLE INSPECTION ).
    2. Inspection (See INSPECTION ).
    3. Terminals of ECU (See TERMINALS OF ECU ).
  5. ADJUSTMENT, REPAIR OR REPLACEMENT 

    END 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.