Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
Pattern Select Switch
NOTE:
For circuit reference, see WIRING DIAGRAMS and/or CONNECTOR IDENTIFICATION
.
Disconnect pattern select switch connector. Using ohmmeter, check continuity between specified terminals. See PATTERN SELECT SWITCH CONTINUITY table. Replace switch as necessary.
PATTERN SELECT SWITCH CONTINUITY
| Switch Position | Terminals No. | Continuity | |||||||
|---|---|---|---|---|---|---|---|---|---|
| GS 300 & GS 430 (1) | |||||||||
| PWR | 3 & 7 | Yes | |||||||
| NORM | 1 & 3; 3 & 7 | No | |||||||
| SNOW | 1 & 3 | Yes | |||||||
| IS 300 (2) | |||||||||
| PWR | 1 & 6 | Yes | |||||||
| NORM | 1 & 3; 1 & 6 | No | |||||||
| SNOW | 1 & 3 | Yes | |||||||
| LS 430 (3) | |||||||||
| PWR | 1 & 6 | Yes | |||||||
| NORM | 1 & 3 & 1 & 6 | No | |||||||
| SNOW | 1 & 3 | Yes | |||||||
| SC 430 (3) | |||||||||
| PWR | 1 & 6 | Yes | |||||||
| NORM | 1 & 3; 1 & 6 | No | |||||||
| SNOW | 1 & 3 | Yes | |||||||
|
|||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
