2002 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

Lexus IS300

  1. Disconnect the solenoid connector. Using an ohmmeter, measure the resistance between terminals. See Fig 1. Resistance should be 12-17 ohms. If resistance value is not as specified, replace the solenoid. See KEY INTERLOCK SOLENOIDΒ  under REMOVAL & INSTALLATION.
  2. Momentarily apply battery positive voltage to terminal KLS+ and ground terminal KLS-. See Fig 1. Ensure an operating noise can be heard from the solenoid. If the solenoid does not operate, replace the solenoid. See KEY INTERLOCK SOLENOIDΒ  under REMOVAL & INSTALLATION.
Fig 1: Measuring Resistance Of Key Interlock Solenoid (Lexus IS300)
G00139872Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.