Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |||
|---|---|---|---|---|
| Axle Hub Lock Nut | 147 (199) | |||
| Brake Caliper Bolts | 87 (118) | |||
| Camber Adjusting Cam Nut | 127 (172) | |||
| Lower Control Arm Assembly | 121 (164) | |||
| Lower Control Arm-To-Lower Ball Joint | 119 (162) | |||
| Lower Ball Joint | 83 (113) | |||
| No. 2 Lower Control Arm-To-Lower Control Arm | 44 (59) | |||
| Piston Rod Lock Nut | 21 (28) | |||
| Shock Absorber-To-Shock Absorber Bracket | 116 (157) | |||
| Spring Support Reinforcement | 41 (56) | |||
| Stabilizer Bar Link-To-Lower Control Arm | 83 (113) | |||
| Stabilizer Link | 83 (113) | |||
| Stabilizer Link-To-Stabilizer Bar | 38 (51) | |||
| Steering Gear Assembly | 48 (65) | |||
| Steering Knuckle-To-Lower Ball Joint | 83 (113) | |||
| Steering Knuckle-To-Upper Control Arm | 64 (87) | |||
| Steering Rack Housing Bracket No. 2 | 48 (65) | |||
| Strut Bar Bracket | 43 (58) | |||
| Suspension Arm Sub-Assembly & Strut Bar Bracket (1) | ||||
| Bolt A | 121 (164) | |||
| Nut B | 112 (152) | |||
| Suspension Member Brace Bolts | 41 (56) | |||
| Suspension Member Brace Rear Nuts | 43 (58) | |||
| Suspension Upper Arm-To-Steering Knuckle | 64 (87) | |||
| Tie Rod-To-Lower Ball Joint | 64 (87) | |||
| Upper Control Arm | 39 (53) | |||
| Wheel Hub Ornament | 15 (20) | |||
| Wheel Lug Nut | 76 (103) | |||
| INCH Lbs. (N.m)Β | ||||
| Speed Sensor Wire Harness | 48 (5) | |||
| ABS Speed Sensor-To-Steering Knuckle | 69 (7.8) | |||
| Brake Dust Cover-To-Steering Knuckle | 74 (8.3) | |||
| Height Control Sensor Link | 48 (5.4) | |||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
