Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
Wireless Door Lock Control Receiver Circuit
WARNING: This page is about a different car, the 2002 Lexus GS 430 and 2002 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
See WIRELESS DOOR LOCK TUNER under CIRCUIT TESTS in BODY CONTROL SYSTEMS article under COMMUNICATION DEVICES in ACCESSORIES & EQUIPMENT.
- Connector Disconnected -
Disconnect the connector from the receiver and inspect the connector on the wire harness side. See INSPECTING WIRELESS DOOR LOCK CONTROL RECEIVER CIRCUIT (CONNECTOR DISCONNECTED) table. See CONNECTOR IDENTIFICATION . If the circuit is not as specified, inspect the circuits connected to other parts.INSPECTING WIRELESS DOOR LOCK CONTROL RECEIVER CIRCUIT (CONNECTOR DISCONNECTED)
Tester Connection Condition Specified Condition 1 - Ground Constant Continuity 7 - Ground Constant B+ Voltage - Connector Connected -
Inspect the wireless door lock control receiver circuit. Connect the wire harness side connector to the receiver and inspect the wire harness side connector from the back side. See INSPECTING WIRELESS DOOR LOCK CONTROL RECEIVER CIRCUIT (CONNECTOR CONNECTED) table. See CONNECTOR IDENTIFICATION . If the circuit is as specified, replace the receiver. If the circuit is not as specified, inspect the circuits connected to other parts.INSPECTING WIRELESS DOOR LOCK CONTROL RECEIVER CIRCUIT (CONNECTOR CONNECTED)
Tester Connection Condition Specified Condition 3 - Ground Ignition Switch Position OFF, Key Removed, Transmitter OFF - ON 4.5-5.5 Volts - Below 1 Volt 4 - Ground Ignition Switch Position OFF, Key Removed, Transmitter ON 10-14 Volts
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
