Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 559 (Stop Light System): Inspection
- INSPECT STOP LIGHT SWITCH CONTINUITYÂ SPECIFIED CONDITION TABLE
Switch position Tester connection Specified condition Switch pin free (Pedal depressed) 1 - 2 Continuity Switch pin pushed in (Pedal released) - No continuity Switch pin free (Pedal depressed) - No continuity Switch pin pushed in (Pedal released) 3 - 4 Continuity If continuity is not as specified, replace the switch.
- INSPECT STOP LIGHT SWITCH CIRCUITÂ
Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown in Fig 2 .
SPECIFIED CONDITION TABLETester connection Condition Specified condition 2 - Ground Always Battery positive voltage If circuit is not as specified, inspect the power source or the wire harness.
- w/o REAR SPOILER: INSPECT HI-MOUNTED STOP LIGHT CONTINUITYÂ
Using an ohmmeter, check that continuity exists between terminals.
If continuity is not as specified, replace the light assembly.
- w/o REAR SPOILER: INSPECT HI-MOUNTED STOP LIGHT CIRCUITÂ
Disconnect the connector from the light and inspect the connector on the wire harness side, as shown in Fig 4 .
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
SPECIFIED CONDITION TABLETester connection Condition Specified condition 2 - Ground Always Continuity If circuit is not as specified, inspect the wire harness.
- w/ REAR SPOILER: INSPECT HI-MOUNTED STOP LIGHT CONTINUITYÂ
Using an ohmmeter, check that continuity exists between terminals.
If continuity is not as specified, replace the light assembly.
- w/ REAR SPOILER: INSPECT HI-MOUNTED STOP LIGHT CIRCUITÂ
Disconnect the connector from the light and inspect the connector on the wire harness side.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
SPECIFIED CONDITION TABLETester connection Condition Specified condition 2 - Ground Always Continuity If circuit is not as specified, inspect the wire harness.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
