Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
Section 547 (Mayday System): Replacement
WARNING: This page is about a different car, the 2004 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
- The installation procedures are the removal procedures in reverse order.
- A bolt without a torque specification is shown in the standard bolt chart (see SUSPENSION CONTROL SYSTEM ).
- Fixed type: REMOVE REAR SEAT CUSHION ASSY (see OVERHAUL )
- Fixed type: REMOVE REAR SEATBACK ASSY (see OVERHAUL )
- Power adjuster type: REMOVE REAR SEAT CUSHION ASSY LH (see OVERHAUL )
- Power adjuster type: REMOVE REAR SEAT CUSHION ASSY RH (see OVERHAUL )
- Power adjuster type: REMOVE REAR SEATBACK ASSY LH (see OVERHAUL )
- Power adjuster type: REMOVE REAR SEATBACK ASSY RH (see OVERHAUL )
- REMOVE REAR DOOR SCUFF PLATE LH (see OVERHAUL )
- REMOVE REAR DOOR SCUFF PLATE RH (see OVERHAUL )
- REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH (see OVERHAUL )
- REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH (see OVERHAUL )
- REMOVE REAR SEAT SIDE COVER LH (see OVERHAUL )
- REMOVE REAR SEAT SIDE COVER RH (see OVERHAUL )
- REMOVE PACKAGE TRAY TRIM PANEL ASSY (see OVERHAUL )
- REMOVE PACKAGE TRAY TRIM PANEL ASSY NO.2 (see OVERHAUL )
- REMOVE ROOM PARTITION NET ASSY (see OVERHAUL )
- REMOVE LUGGAGE COMPARTMENT FLOOR MAT (see OVERHAUL )
- REMOVE ROPE HOOK ASSY (see OVERHAUL )
- REMOVE REAR FLOOR FINISH PLATE (see OVERHAUL )
- REMOVE TOOL CASE (see OVERHAUL )
- REMOVE SIDE TRIM TOOL BAG COVER (see OVERHAUL )
- REMOVE COVER, LUGGAGE COMPARTMENT TRIM, FR (see OVERHAUL )
- REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSY LH (see OVERHAUL )
- REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSY RH (see OVERHAUL )
- REMOVE MAYDAY ASSY
- Remove the 3 nuts.
- Disconnect the 4 connectors and 3 clamps.
- Remove the Mayday assy.
- REMOVE BUS BUFFER ECU
- Disconnect the connector.
- Remove the ECU as shown in the illustration.
- REMOVE MAYDAY ECU ASSY
- Remove the 2 bolts and mobile Phone bracket No. 1.
- Disconnect the 2 connectors.
- Remove the 3 bolts and ECU.
- REMOVE PORTABLE PHONE-L BATTERY
- Remove the nut and mobile phone bracket No. 2.
- Disconnect the connector and remove the portable-phone-L battery.
- REMOVE TELEPHONE TRANSCEIVER ASSY
- Disconnect the connectors.
- Remove the 3 screws and telephone transceiver.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
