Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
On-Vehicle Repair
WARNING: This page is about a different car, the 2003 Lexus LX 470. However, it is still accessible from the selected car via links, so may be relevant.
- DISCONNECT No. 1 VEHICLE SPEED SENSOR CONNECTORÂ
- REMOVE No. 1 VEHICLE SPEED SENSORÂ
Remove the bolt and the No. 1 vehicle speed sensor.
- DISASSEMBLE No. 1 VEHICLE SPEED SENSORÂ
- Remove the O-ring from the speedometer driven gear assembly.
- Remove the clip and the speedometer driven gear from the speedometer driven gear sleeve.
- ASSEMBLE No. 1 VEHICLE SPEED SENSORÂ
- Install the speedometer driven gear and the clip to the speedometer driven gear sleeve.
- Coat a new O-ring with ATF.
- Install the O-ring to the speedometer driven gear assembly.
- INSTALL No. 1 VEHICLE SPEED SENSORÂ
Install the No. 1 vehicle speed sensor with the bolt.
Torque: 16 N.m (160 kgf.cm, 12 ft.lbf)Â
- CONNECT No. 1 VEHICLE SPEED SENSOR CONNECTORÂ
- DISCONNECT SPEED SENSOR NT AND SP2 CONNECTORSÂ
- REMOVE SPEED SENSOR NT AND SP2Â
- Remove the 2 bolts, speed sensor NT and SP2.
- Remove 2 O-rings from the speed sensor NT and SP2.
- INSTALL SPEED SENSOR NT AND SP2Â
- Coat 2 new O-rings with ATF and install them to the speed sensor NT and SP2.
- Install the speed sensor NT and SP2 with 2 bolts.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)Â
- CONNECT SPEED SENSOR NT AND SP2 CONNECTORSÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
