Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 469 (Interior Light System): Inspection
- Overhead J/B side: INSPECT FRONT PERSONAL LIGHT ASSEMBLYÂ
Disconnect the overhead J/B assembly connector.
CONNECTOR SPECIFIED CONDITIONTester condition Tester connection Specified condition OFF - No continuity Personal light ON 5 - 17 Continuity RH side console spot light 5 - 17 Continuity LH side console spot light 5 - 17 Continuity Personal light DOOR 6 - 17 Continuity If continuity is not as specified, replace the overhead J/B assembly.
- Rear room light: INSPECT REAR PERSONAL LIGHT ASSEMBLY CONTINUITYÂ CONNECTOR CONTINUITY
Switch position Tester connection Specified condition Room light switch off and door close - No continuity Room light switch on and door close 1 - 2 Continuity Room light switch off or ON and door open 1 - 3 Continuity If continuity is not as specified, replace bulb or rear personal light assembly.
- INSPECT VANITY LIGHT CONTINUITYÂ VANITY LIGHT CONTINUITY
Switch position Tester connection Specified condition OFF (closed) - No continuity ON (opened) 1 - 2 Continuity If continuity is not as specified, replace the vanity light assembly or bulb.
- INSPECT DOOR COURTESY SWITCH CONTINUITYÂ
- Check that continuity exists between terminals and the switch body with the switch ON (switch pin released: opened door).
- Check that no continuity exists between terminals and the switch body with the switch OFF (switch pin pushed in: closed doors)
If operation is not as specified, replace the switch.
- INSPECT DOOR COURTESY LIGHT CONTINUITYÂ
Using an ohmmeter, check that continuity exists between terminals.
If continuity is not as specified, replace the light assembly or bulb.
- INSPECT LUGGAGE COMPARTMENT LIGHT CONTINUITYÂ
Using an ohmmeter, check that continuity exists between terminals.
If continuity is not as specified, replace the light assembly or bulb.
- INSPECT GLOVE COMPARTMENT LIGHT CONTINUITYÂ
Using the ohmmeter, check that continuity exists between terminals.
If continuity is not as specified, replace the light assembly or bulb.
- INSPECT LICENSE PLATE LIGHT CONTINUITYÂ
Using the ohmmeter, check that continuity exists between terminals.
If continuity is not as specified, replace the light assembly or bulb.
- INSPECT STEP LIGHT CONTINUITYÂ
Using the ohmmeter, check that continuity exists between terminals.
If continuity is not as specified, replace the light assembly or bulb.
- INSPECT OUTER FOOT LIGHTÂ
Connect the positive (+) lead from the battery to terminal 10 and the negative (-) lead to terminal 2,and check that the outer foot light goes on.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
