2002 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

Section 428 (Instrument Panel): Disassembly

WARNING: This page is about a different car, the 2003 Lexus LX 470. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT 
  2. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT 
  3. REMOVE DEFROSTER NOZZLE 
  4. REMOVE CENTER BRACKET 
  5. REMOVE NO. 1 HEATER TO REGISTER DUCT 
  6. REMOVE INSTRUMENT PANEL WIRE HARNESS 
  7. REMOVE NO. 5 HEATER TO REGISTER DUCT 
  8. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY 

    Remove the 3 nuts and the front passenger airbag assembly.

    Torque: 6.0 N.m (61 kgf.cm, 53 in..lbf) 

    CAUTION:
    • Do not store the front passenger airbag assembly with the airbag deployment side facing down. 
    • Never disassemble the front passenger airbag assembly. 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.