2002 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

Terminals Of Ecu

WARNING: This page is about a different car, the 2004 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK THEFT WARNING ECU 
    Fig 1: Identifying Terminals Of ECU
    G01444217Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the T5 ECU connector.
    2. Measure the resistance and voltage of each terminal of the wire harness side connector.

      Standard: 

      Fig 2: Voltage Specifications (1 Of 3)
      G01444218Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, there may be a malfunction on the wire harness side.

    3. Reconnect the T5 ECU connector.
    4. Measure the voltage and frequency of each terminal of the connector.

      Standard: 

      Fig 3: Voltage Specifications (2 Of 3)
      G01444219Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    Fig 4: Voltage Specifications (3 Of 3)
    G01444220Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    If the result is not as specified, the theft warning ECU may have a malfunction.

  2. CHECK STEERING LOCK ECU 
    Fig 5: Identifying Steering Lock ECU Terminals
    G01444221Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the S46 ECU connector.
    2. Measure the resistance and voltage of each terminal of the wire harness side connector.

      Standard: 

      Fig 6: Resistance Specifications
      G01444222Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, there may be a malfunction on the wire harness side.

    3. Reconnect the S46 ECU connector.
    4. Check the resistance and voltage of each terminal of the connector.

      Standard: 

      Fig 7: Voltage Specifications
      G01444223Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    If the result is not as specified, the steering lock ECU may have a malfunction.

    1. Inspect using an oscilloscope.
      Fig 8: Waveform 1 Reference Table
      G01444224Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.