Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
Wheel Speed Sensor (Front): Installation
- To install, reverse removal procedure. Tighten speed sensor bolt to specification. See TORQUE SPECIFICATIONS .
- Install the sensor harness with the 2 clamp bolts and resin clip to the body and tighten to specification. See TORQUE SPECIFICATIONS .
- Connect the speed sensor connector.
- Install the front fender liner and front wheel and tighten lug nuts to specification. See TORQUE SPECIFICATIONS .
- Install the ornament with the 10 bolts and tighten to specification. See TORQUE SPECIFICATIONS .
- Check speed sensor signal. See SYSTEM TESTING .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
