2002 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

Steering Sensor: Installation

  1. To install, reverse removal procedure. Ensure front wheels are in straight ahead position.
  2. Tighten steering wheel assembly to specification. See TORQUE SPECIFICATIONSΒ .
  3. Tighten horn button assembly to specification. See TORQUE SPECIFICATIONSΒ .
  4. Inspect SRS warning light. See DIAGNOSTIC TESTS article AIR BAG RESTRAINT SYSTEMS.
  5. Perform steering angle sensor zero point calibration.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.