Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus LX 470FACTORY OEM SERVICE PROCEDURE
Setting Driving Position
- Adjust the driver's seat, tilt and telescopic steering and outside rear view mirrors to the desired position.
- While pushing the SET button, push button 1 or 2 until the signal beeps. The beep sound means that the positions are recorded in the computer's memory.
- By repeating these 2 steps and pressing the remaining button, the driving position for another driver can be recorded.
- To set a new memorized position, select the desired position and perform step 2. The previous memory will be erased and the new position will be set.
- To make only slight changes to an already memorized position, the easiest way is to first activate the memorized position, then make the desired changes and perform step 2.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.