2002 Lexus LS 430FACTORY OEM SERVICE PROCEDURE

Power Steering Gear: Replacement

CAUTION: When using a vise, do not overtighten it.
  1. If necessary, replace bearing and oil seal.
    1. Using SST, remove the bearing from the rack housing.
      Fig 1: Removing Bearing From Rack Housing With SST
      G01148650Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
      1. SST 09612-30012
      CAUTION: Be careful not to damage the rack housing.
    2. Using SST, remove the oil seal from the rack housing.
        Fig 2: Removing Oil Seal From Rack Housing With SST
        G01148651Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
      1. SST 09612-30012
      CAUTION: Be careful not to damage the rack housing.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.