Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 428 (Fog Light System): Inspection
- INSPECT FOG LIGHT SWITCH CONTINUITY TESTER CONNECTION
Switch position Tester connection Specified condition OFF - No continuity ON 10-11 Continuity If continuity is not as specified, replace the switch.
- Connector disconnected: INSPECT FOG LIGHT SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.
CONTINUITYTester connection Condition Specified condition 10-17 Constant Continuity If circuit is not as specified, inspect the wire harness.
- Connector connected: INSPECT FOG LIGHT SWITCH CIRCUIT
Connect the wire harness side connector to the light control and the dimmer switch, and inspect the connector from the back side, as shown.
SPECIFICATION CONDITIONTester connection Condition Specified condition 10-Ground Light control switch HEAD and headlight dimmer switch LO and fog light switch ON No voltage 10 - Ground Light control switch HEAD and headlight dimmer switch HI or FLASH and fog light switch ON Battery positive voltage If circuit is not as specified, inspect the wire harness.
- FOG LIGHT RELAY: INSPECT ENGINE ROOM R/B RELAY CIRCUIT (See
INSPECTION
)
HINT:
The foglight relay is built in engine room junction block. Also, the relay is constructed with a relay block that is in the junction block as a unit. To disconnect the wire harness connecting with relay block is impossible. If the relay has a malfunction, replace it with junction block assembly wire harness together.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
