2002 Lexus LS 430FACTORY OEM SERVICE PROCEDURE

Solar Sensor: Inspection

WARNING: This page is about a different car, the 2003 Lexus LX 470. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE SOLAR SENSOR 

    sing a screwdriver, pull out the solar sensor, then disconnect the connector.

    HINT:

    Tape up the screwdriver tip before use.

    Fig 1: Removing Solar Sensor
    G01352508Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT SOLAR SENSOR CIRCUIT (See  DTC 21: SOLAR SENSOR CIRCUIT  ) 
  3. INSTALL SOLAR SENSOR 
    1. Connect the connector.
    2. Insert the solar sensor to the instrument panel.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.