2002 Lexus LS 430FACTORY OEM SERVICE PROCEDURE

Air Conditioning System: Precaution

WARNING: This page is about a different car, the 2003 Lexus LX 470. However, it is still accessible from the selected car via links, so may be relevant.
  1. DO NOT HANDLE REFRIGERANT IN AN ENCLOSED AREA OR NEAR AN OPEN FLAME 
  2. ALWAYS WEAR SAFETY GLASSES FOR EYE PROTECTION 
  3. AVOID YOUR EYES AND SKIN TO CONTACT WITH LIQUID REFRIGERANT 

    If you get the liquid refrigerant in your eyes or on your skin:

    1. Wash out the area with lots of cold water.
      CAUTION: Do not rub your eyes or skin.
    2. Apply clean petroleum jelly to the skin.
    3. Go immediately to a physician or hospital for professional treatment.
  4. NEVER HEAT CONTAINER OR EXPOSE IT TO NAKED FLAME 
  5. BE CAREFUL NOT TO DROP CONTAINER AND NOT TO APPLY PHYSICAL SHOCKS TO IT 

    Do not drop container nor apply physical shocks to it.

    Fig 1: Avoid Your Eyes And Skin To Contact With Liquid Refrigerant
    G01352362Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. DO NOT OPERATE COMPRESSOR WITHOUT ENOUGH REFRIGERANT IN REFRIGERANT SYSTEM 

    If there is not enough refrigerant in the refrigerant system, oil lubrication will be insufficient and compressor burnout may occur. To avoid this, always keep enough refrigerant in the refrigerant system.

  7. DO NOT OPEN HIGH PRESSURE MANIFOLD VALVE WHILE COMPRESSOR IS OPERATING 

    If the high pressure valves opened, refrigerant flows in the reverse direction and could cause the charging cylinder to rupture, so open and close the only low pressure valve.

    Fig 2: Identifying Low Pressure Valve Use Only
    G01352363Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. DO NOT OVERCHARGE REFRIGERANT SYSTEM WITH REFRIGERANT 

    If refrigerant is overcharged, it causes problems such as insufficient cooling, poor fuel economy, engine overheating etc.

  9. SUPPLEMENTAL RESTRAINT SYSTEM (SRS) 

    The LEXUS LX470 is equipped with SRS (Supplemental Restraint System) such as the driver airbag and the front passenger airbag. Failure to carry out service operation in the correct sequence could cause the SRS to unexpectedly deploy during servicing, possibly leading to a serious accident. Before servicing (including removal or installation of parts, inspection or replacement), see AIR BAG SAFETY PRECAUTIONS .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.