Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Crankshaft Position Sensor: Replacement
- Remove engine under cover.
- Remove Crankshaft Position (CKP) sensor.
- Disconnect the CKP sensor connector.
- Remove the bolt and CKP sensor
- Reinstall new CKP sensor.
- Install a new CKP sensor with the bolt.
- Torque : 6.5 N.m (65 kgf.cm, 58 in.lbf)
- Connect the CKP sensor connector.
- Install a new CKP sensor with the bolt.
- Reinstall engine under cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.