Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus IS 300 Base, StandardFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Back-Up Light Switch Bolt | 30 (40) | |
| Center Exhaust Pipe-To-Tailpipe Bolt | 32 (43) | |
| Clutch Cover Bolt | 14 (19) | |
| Clutch Pedal Height Lock Nut | 12 (16) | |
| Clutch Release Fork Support Bolt | 29 (39) | |
| Drive Shaft Center Bearing Bolt | 36 (49) | |
| Drive Shaft Flange Bolt | 55 (74) | |
| Exhaust Manifold-To-Engine Nut | 29 (39) | |
| Exhaust Pipe-To-Manifold Nut | 46 (62) | |
| Exhaust Pipe-To-Pipe Support Bracket Bolt | 32 (43) | |
| Flywheel Bolt | 61 (83) | |
| Ground Wire Bolt | 27 (37) | |
| Rear Engine Mounting Bolt | 19 (26) | |
| Rear Engine Mounting Member | ||
| Bolt | 18 (25) | |
| Nut | 10 (14) | |
| Starter Bolt | 28 (38) | |
| Transmission Filler & Drain Plug | 28 (38) | |
| Transmission Mounting Bolt | ||
| Bolt "A" (12 mm head) | 53 (72) | |
| Bolt "B" (10 mm head) | 28 (38) | |
| INCH Lbs. (N.m) | ||
| Back-Up Light Switch Clamp Bolt | 53 (6) | |
| Clutch Hydraulic Line Fitting | 133 (15) | |
| Clutch Master Cylinder Nut | 106 (12) | |
| Clutch Release Cylinder Bleeder Plug | 97 (11) | |
| Clutch Release Cylinder Bolt | 106 (12) | |
| No. 1 Engine Cover Nut | 44 (5) | |
| Push Rod Play & Adjust Lock Nut | 106 (12) | |
| Shift Lever-To-Control Shift Lever Arm Bolt | 71 (8) | |
| Starter Wire Nut | 88 (10) | |
| Vehicle Speed Sensor Bolt | 124 (14) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
