2002 Lexus IS 300 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

Switches Location

Component Component Location
A/C Triple Pressure Switch On left front of engine compartment, behind bumper fascia.
Brake Fluid Level Warning Switch On brake fluid reservoir, on top of brake master cylinder.
Buckle Switch (Left) Inside of left front seat belt buckle.
Buckle Switch (Right) & Seat Belt Warning Occupant Detection Sensor Inside of right front seat belt buckle.
Engine Hood Courtesy Switch On front center of engine compartment, near hood latch.
Engine Oil Pressure Switch On left front of engine. See Figure.
Parking Brake Switch At base of parking brake lever. See Figure.
Park/Neutral Position Switch On right side of transmission. See Figure.
Stoplight Switch Above brake pedal, on bracket. See Figure.
Water Temperature Switch On right side of radiator. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.