2002 Lexus IS 300 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Connectors

Connectors Location

Component Component Location
BA1 (12 Pin) At left "B" pillar.
BB1 (12 Pin) At right "B" pillar.
BC2 (18 Pin) At right rear floor partition panel.
BD1 (3 Pin) At lower left back panel.
BE1 (Gray, 2 Pin) Near left license light.
BF1 (Gray, 2 Pin) Near right license light.
BG1 (6 Pin) Under left front seat.
BH1 (6 Pin) Under right front seat.
BJ1 (4 Pin) At upper left side of back panel.
BJ2 (Blue, 10 Pin) At upper left side of back panel.
BK1 (Blue, 12 Pin) At lower left side of back panel.
BK2 (3 Pin) At lower left side of back panel.
EA1 (Gray, 10 Pin) Inside ECU box. See Figure.
EA2 (Blue, 9 Pin) Inside ECU box. See Figure.
EA3 (11 Pin) Inside ECU box. See Figure.
IA1 (Blue, 20 Pin) Near left side J/B. See Figure.
IA3 (20 Pin) Near left side J/B. See Figure.
IB1 (Gray, 22 Pin) Near left side J/B. See Figure.
IB3 (Gray, 20 Pin) Near left side J/B. See Figure.
IC1 (8 Pin) Near left side J/B. See Figure.
ID2 (17 Pin) At left kick panel. See Figure.
IE1 (5 Pin) At left side of dash. See Figure.
IF1 (14 Pin) At left side of blower unit. See Figure.
IF2 (3 Pin) At left side of blower unit. See Figure.
IG1 (Blue, 17 Pin) Near right side J/B. See Figure.
IG2 (Yellow, 4 Pin) Near right side J/B. See Figure.
IG3 (10 Pin) Near right side J/B. See Figure.
IH1 (22 Pin) Near right side J/B. See Figure.
IH3 (Gray, 14 Pin) Near right side J/B. See Figure.
IH4 (Gray, 14 Pin) Near right side J/B. See Figure.
II1 (20 Pin) At right kick panel. See Figure.
IJ1 (4 Pin) At left side of dash. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.