Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus IS 300 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Brake Line
- Fill brake reservoir with appropriate brake fluid.
- Connect a vinyl tube to bleeder valve on brake caliper and place the other end in a clear jar.
- Depress brake pedal several times. Loosen bleeder valve with brake pedal held down.
- At the point when fluid flow stops, tighten the bleeder valve to specification. See TORQUE SPECIFICATIONS .
- Release brake pedal. Repeat steps 3 and 4 until all air in fluid has been bled out.
- Repeat procedure to bleed air out of brake line for each wheel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.