2002 Lexus IS 300 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Without Hand-Held Sensor

  1. Turn the ignition switch OFF.
  2. Using special tool (09843-18040), connect terminals Tc and CG of DLC3. See Figure.
  3. Start the engine and check that the ABS warning light blinks. If the ABS warning light does not blink, inspect the ABS warning light circuit and Ts circuit. See SYSTEM TESTINGΒ .
  4. Drive the vehicle straight forward and faster than 28 mph (45 km/h) for several seconds. Check that the ABS warning light comes off.
  5. Stop the vehicle.
  6. Read the number of blinks of the ABS warning light. If every sensor is normal, there is a normal code output (0.25 second ON and 0.25 second OFF). For abnormal codes see DIAGNOSTIC TROUBLE CODE DEFINITIONSΒ .
  7. If 2 or more malfunctions are indicated at the same time, the lowest numbered code will be displayed first.
  8. After doing the check, turn the ignition switch OFF and remove the special tool from the DLC3.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.