Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus IS 300 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
With Hand-Held Tester
- Hook up the hand-held tester to the DLC3. See Figure.
- Start the engine and check that the ABS warning light blinks. If the ABS warning light does not blink, inspect the ABS warning light circuit and Ts circuit. See SYSTEM TESTINGΒ .
- Drive the vehicle straight forward and faster than 28 mph (45 km/h) for several seconds. Check that the ABS warning light comes off.
- Stop the vehicle. Read the DTC by following prompts on the tester screen. Refer to the hand-held tester operator's manual for further details.
- Stop the engine.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
