2002 Lexus IS 300 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

With Hand-Held Tester

  1. Hook up the hand-held tester to the DLC3. See Figure.
  2. Turn the ignition switch OFF. Set the shift lever to P position.
  3. Check that the steering wheel is in the straight ahead position.
  4. Turn the ignition switch ON. Check that the ABS warning light blinks.
  5. If the ABS warning light does not blink, inspect the ABS warning light circuit or Ts terminal circuit. See SYSTEM TESTINGΒ .
  6. Pump the brake pedal to fill the booster vacuum. This will check the brake pedal load sensing switch.
  7. Turn the ignition switch to ON (do not start the engine) and keep depressing the brake pedal for 1 second or more with a force of approximately 14 lbf (59 N) or more.
  8. Check that the brake warning light is lit and the operating sound of the ABS motor is heard.
  9. Start the engine. Check that the brake warning light goes out. Release the brake pedal.
  10. When rechecking, exit the test mode and then activate the test mode again.
  11. Check the deceleration sensor by keeping the vehicle in a stationary condition on a level place for 1 second or more.
  12. Check the master cylinder pressure sensor by leaving the vehicle in a stationary condition and the brake pedal in free condition for 1 second or more, continue to depress the brake pedal with a force of 22 lbf (98 N) or more for 1 second or more.
  13. While the vehicle is stopped, release the brake pedal. Quickly depress the brake pedal once or more and check the ABS warning light is lit for 3 seconds.
  14. Read the DTC by following the prompts on the tester screen. See DIAGNOSTIC TROUBLE CODE DEFINITIONSΒ . Refer the hand-held tester operator's manual for further details.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.