Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Code Definitions: Notes
| DTC | Description |
|---|---|
| DTCS C0200, C0205, C0210, C0215, C1235, C1236, C1238 & C1239 | SPEED SENSOR CIRCUIT |
| DTCS C0226, C0236, C0246 & C0256 | ABS-RELATED SOLENOID CIRCUITS |
| DTCS C0273 & C0274 | ABS MOTOR RELAY CIRCUIT |
| DTCS C0278 & C0279 | ABS SOLENOID RELAY CIRCUIT |
| DTC C1201 | ENGINE CONTROL SYSTEM MALFUNCTION |
| DTC C1202 | BRAKE FLUID WARNING SWITCH CIRCUIT |
| DTC C1203 | ECM COMMUNICATION CIRCUIT MALFUNCTION |
| DTC C1223 | ABS CONTROL SYSTEM MALFUNCTION |
| DTC C1224 | NE SIGNAL CIRCUIT |
| DTCS C1225, C1226, & C1227 | TRAC & VSC RELATED SOLENOID CIRCUITS |
| DTCS C1231 & C1335 | STEERING ANGLE SENSOR CIRCUIT |
| DTCS C1233 & C1234 | YAW RATE SENSOR CIRCUIT |
| DTC C1241 | IG POWER SOURCE CIRCUIT |
| DTC C1246, C1360 | |
| DTC C1249 | OPEN CIRCUIT IN STOP LIGHT SWITCH CIRCUIT |
| DTC C1251 | ABS PUMP MOTOR LOCK |
| DTC 1267 | BRAKE PEDAL LOAD SENSING SWITCH |
Using special tool (09843-18040), connect the terminals Tc and CG of DLC3. See Figure. If any abnormality is not found on inspected parts, inspect the ECU and wiring harness. If a malfunction code is displayed during the DTC check, check the circuit indicated by DTC. For details of each code, see DIAGNOSTIC TESTS .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
