Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
For circuit wiring diagram, see Fig 1.
Check for short to power, short to ground and continuity in the wiring harness and connectors between the master switch and body ECU No. 1, and door lock switch of passenger door and body ECU No. 1. If the results are OK, inspect the power window master switch circuit. See POWER WINDOW MASTER SWITCH CIRCUIT (DRIVER) under CIRCUIT TESTS under POWER WINDOWS in WINDOWS. If the results are not OK, repair or replace the wiring harness or connector.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
