2002 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Charging Systems: Generator: Removal

  1. Remove engine under cover.
  2. Remove air cleaner inlet.
  3. Remove drive belt.

    Loosen the belt tension by turning the drive belt tensioner counterclockwise, and remove the dive belt.

    Fig 1: Removing Drive Belt
    G01132883Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.