Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus ES 300FACTORY OEM SERVICE PROCEDURE
Cruise Control Main Switch: Replacement
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
Installation is in the reverse order of removal.
- PRECAUTION (SEE AIR BAG RESTRAINT SYSTEMS )
- DISCONNECT BATTERY NEGATIVE TERMINAL (SEE AIR BAG RESTRAINT SYSTEMS )
- REMOVE STEERING WHEEL COVER LOWER NO.2
- REMOVE STEERING WHEEL COVER LOWER NO.3
- REMOVE HORN BUTTON ASSY (SEE AIR BAG RESTRAINT SYSTEMS )
- REMOVE CRUISE CONTROL MAIN SWITCH
- Disconnect the connector.
- Remove the 2 screws and cruise control main switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
