2002 Lexus ES 300FACTORY OEM SERVICE PROCEDURE

Section 137 (Hybrid Control System): Inspection

WARNING: This page is about a different car, the 2004 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT INTEGRATION RELAY (IGCT RELAY) 
    1. Check the HEV fuse.
      1. Remove the 20 A fuse. Using an ohmmeter, measure the resistance between the terminals.
      1. Standard: Below 1 Ω 

      If the standard is not met, replace the fuse.

      Fig 1: Identifying Integration Relay Connection Terminals
      G02920895Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check the IGCT relay.
      1. Using an ohmmeter, measure the resistance between the terminals.

        Standard: 

        TESTER CONNECTION SPECIFIED CONDITION

        Tester Connection Specified Condition
        7J-1 - 7J-4 10 kΩ or higher
        7J-1 - 7K-1 Below 1 Ω
        7J-2 - 7J-3 Below 1 Ω
        7J-4 - 7K-1 10 kΩ or higher

        If the standards are not met, replace the integration relay.

      2. Using an ohmmeter, measure the resistance between the terminals when battery voltage is applied to terminals 7J-2 and 7J-3.

        Standard: 

        TESTER CONNECTION SPECIFIED CONDITION

        Tester Connection Specified Condition
        7J-1 - 7J-4 Below 1 Ω
        7J-1 - 7K-1 Below 1 Ω

        If the standards are not met, replace the integration relay.

  2. INSPECT WATER W/MOTOR & BRACKET PUMP ASSY 
    1. Check the operation.
      1. Connect the battery positive terminal to terminal 1 and the battery negative terminal to terminal 2, then check that the pump motor operates properly.
      NOTE:
      • Do not connect the positive and negative poles of the battery to the wrong terminals.
      • Complete the check within 10 seconds of connection.

      If it does not operate properly, replace the water pump with motor and bracket.

      Fig 2: Identifying Water/Motor & Bracket Pump Assy Connector Terminals
      G02920896Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.