Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus ES 300FACTORY OEM SERVICE PROCEDURE
Driver Side Junction Block
- Disconnect the body ECU connectors 2A, 2B, 2D, 2G and 2K. See CONNECTOR IDENTIFICATIONΒ .
- Inspect the voltage and continuity of each terminal of the vehicle's side connector. See INSPECTING DRIVER SIDE JUNCTION BLOCK VOLTAGE & CONTINUITYΒ table. If the value is not as specified, there may be a malfunction in the vehicle's side.INSPECTING DRIVER SIDE JUNCTION BLOCK VOLTAGE & CONTINUITY
Tester Connection Wiring Color Condition (Specified Condition) 2K-11 (B) - 2D-3 (GND) White/Red - White/Black Constant (10-14 Volts) 2H-6 (ACC) - 2D-3 (GND) Blue/Red - White/Black Constant (10-14 Volts) 2G-14 (BDR1) - 2D-3 (GND) Blue/White - White/Black Constant (10-14 Volts) 2H-2 (BDR2) - 2D-3 (GND) White/Black - White/Black Constant (10-14 Volts) 2B-11 (SGND) - Body Ground White/Black - Body Ground Constant (0 Volt - 10-14 Volts) 2A-11 (SGND) - 2D-3 Body Ground White/Black - Body Ground Constant (Continuity) 2D-3 (GND) - Body Ground White/Black - Body Ground Constant (Continuity)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
