Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Lexus ES 300FACTORY OEM SERVICE PROCEDURE
Inspection Procedure
For circuit wiring diagram, see Fig 1.
- Inspect the seat memory switch. See Fig 2. If the results are OK, go to the next step. If the results are not good, replace the seat memory switch.
- Check the seat memory switch and seat position control ECU wiring harnesses. See Fig 3. If the continuity is OK, check and replace the position control ECU assembly. See POSITION CONTROL ECU ASSEMBLYΒ under REMOVAL & INSTALLATION. If the continuity is not good, check and replace the harness and connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
