2001 Lexus RX 300 FWDFACTORY OEM SERVICE PROCEDURE

Front Speed Sensor: Removal

  1. DISCONNECT SPEED SENSOR CONNECTOR 
    1. Remove the front wheel and front fender liner.
    2. Disconnect the speed sensor connector.
    3. Fig 1: Disconnecting Speed Sensor Connector
      G03149561Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE SPEED SENSOR 
    1. Remove the bolt, then disconnect the flexible hose and speed sensor harness clamp from the shock absorber.

      Torque: 29 N.m (300 kgf.cm, 21 ft.lbf) 

    2. Remove the resin clip from the shock absorber.
    3. Remove the bolt and speed sensor harness clamp to the body.

      Torque: 5.0 N.m (55 kgf.cm, 48 in.lbf) 

    4. Remove the bolt and speed sensor from the steering knuckle.

      Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf) 

      Fig 2: Removing Bolt & Speed Sensor From Steering Knuckle
      G03149562Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.