2001 Lexus LX 470FACTORY OEM SERVICE PROCEDURE

Section 249 (Axle Shafts): Description

WARNING: This page is about a different car, the 2003 Toyota Prius and 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

Axle shafts transfer power from transaxle to front wheels. All axle shafts consist of a shaft with a flexible Constant Velocity (CV) joint at each end. Inner CV joint is splined or bolted to transaxle. Outer CV joint is splined to hub assembly, and secured by axle shaft nut.

The inner CV joint is a plunging tripod joint. The plunging action allows for axle shaft length change as suspension moves up and down.

The inner and outer CV joints are enclosed by a CV joint boot. The boot maintains lubrication in the joint and prevents contamination of CV lubricant. Boots must be replaced when signs of leakage or cracks are present. The inner CV joint can be repaired without replacing assembly. The outer CV joint must be replaced as an assembly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.