Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Stop Light Switch
Inspect the stop light switch continuity. See CONNECTOR IDENTIFICATION . See INSPECTING STOP LIGHT SWITCH CONTINUITY table. If continuity is not as specified, replace the switch. See STOP LIGHT SWITCH under REMOVAL & INSTALLATION.
| Switch Position | Tester Connection | Specified Condition |
|---|---|---|
| Switch Pin Free (Pedal Depressed) | 1 - 2 | Continuity |
| Switch Pin Pushed In (Pedal Released) | ..... | No Continuity |
| Switch Pin Free (Pedal Depressed) | ..... | No Continuity |
| Switch Pin Pushed In (Pedal Released) | 3 - 4 | Continuity |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.