Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Sensor Power Source Circuit
- Turn ignition on. Remove tilt and telescopic ECU from its mounting, leaving wiring harness connector attached. Measure voltage by backprobing rear of 16-pin connector terminals No. 13 (Black/Blue wire) and No. 14 (Yellow wire). See Figure. Measure voltage by backprobing rear of 16-pin connector terminals No. 10 (White/Blue wire) and No. 12 (White/Red wire). If voltage is not 4.5-5.5 volts for both measurements, go to step 3. If voltage is 4.5-5.5 volts for both measurements, go to next step.
- Check wiring harness and connectors for an open circuit between 16-pin connector terminals No. 10 (White/Blue wire), No. 12 (White/Red wire), No. 13 (Black/Blue wire) and No. 14 (Yellow wire). See WIRING DIAGRAMS . Repair or replace as necessary. If wiring harness and connectors are okay, go to next test listed in SYMPTOM DIAGNOSIS table under TROUBLE SHOOTING.
- Check wiring harness and connectors for a short circuit between 16-pin connector terminals No. 10 (White/Blue wire), No. 12 (White/Red wire), No. 13 (Black/Blue wire) and No. 14 (Yellow wire). See WIRING DIAGRAMS . Repair or replace as necessary. If wiring harness and connectors are okay, check tilt and telescopic ECU. See TILT & TELESCOPIC ECU PIN VOLTAGE TESTS under PIN VOLTAGE TESTS. Replace tilt and telescopic ECU as necessary and retest system operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
