2001 Lexus LS 430FACTORY OEM SERVICE PROCEDURE

Power Seat Control System: Inspection

WARNING: This page is about a different car, the 2002 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FRONT PASSENGER'S POWER SEAT SWITCH CONTINUITY 
    Fig 1: Identifying Power Seat Switch & Connector Terminals
    G01145597Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Slide switch: 

    Fig 2: Slide Switch Continuity Chart
    G01145593Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Reclining switch: 

    Fig 3: Reclining Switch Continuity Chart
    G01145594Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Front vertical switch: 

    Fig 4: Front Vertical Switch Continuity Chart
    G01145595Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Lifter switch: 

    Fig 5: Lifter Switch Continuity Chart
    G01145596Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    If continuity is not as specified, replace the switch.

  2. INSPECT FRONT PASSENGER'S POWER SEAT SWITCH CIRCUIT 
    1. Disconnect the switch connector and connect the seat wire harness to the floor wire harness.
    2. Inspect the connector on the wire harness side.
      Fig 6: Identifying Front Passengers Power Seat Switch Connector & Terminals
      G01145598Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    Fig 7: Front Passengers Power Seat Switch Circuit Specification Chart
    G01145599Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    If circuit is not as specified, inspect the circuits connected to other parts.

  3. INSPECT DRIVER'S LUMBAR SUPPORT SWITCH CONTINUITY 
    Fig 8: Identifying Lumbar Switch Connector & Terminals
    G01145602Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Upper side control: 

    Fig 9: Upper Side Continuity Chart
    G01145600Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Lower side control: 

    Fig 10: Lower Side Continuity Chart
    G01145601Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    If continuity is not as specified, replace the switch.

  4. INSPECT DRIVER'S LUMBAR SUPPORT SWITCH CIRCUIT 
    1. Disconnect the switch connector and connect the seat wire harness to the floor wire harness.
    2. Inspect the connector on the wire harness side.
      Fig 11: Identifying Drivers Lumbar Support Switch Connector
      G01145603Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    Fig 12: Drivers Lumbar Support Switch Circuit Specification Chart
    G01145604Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    If circuit is not as specified, inspect the circuits connected to other parts.

  5. INSPECT DRIVER'S SEAT CUSHION SWITCH CIRCUIT 
    Fig 13: Identifying Drivers Seat Cushion Switch Connector & Terminals
    G01145606Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.