Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Wiper/Washer Switch Circuit
NOTE:
If LEXUS scan tool is available, start test from step 1. If this scan tool is not available, start test from step 2.
- Using scan tool, check wiper/washer switch using DATA LIST. If wiper/washer switch is faulty, go to next step. If wiper/washer switch is okay, go to next test listed in BODY NO. 3 CONTROL SYSTEM table under TROUBLE SHOOTING .
- Check wiper/washer switch. See WIPER/WASHER SYSTEMS - LS430 article. Replace wiper/washer switch as necessary. Retest system operation. If wiper/washer switch is okay, go to next step.
- Check circuits for faults between wiper/washer switch and body control ECU. See WIRING DIAGRAMS . Repair or replace as necessary. If circuits are okay, go to next test listed in BODY NO. 3 CONTROL SYSTEM table under TROUBLE SHOOTING .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
