Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Washer Fluid Level Sensor Circuit
NOTE:
If LEXUS scan tool is available, start test from step 1. If this scan tool is not available, start test from step 2.
- Using scan tool, operate washer fluid level sensor in ACTIVE LIST. If washer fluid level sensor does not operate, go to next step. If washer fluid level sensor operates, go to next test listed in BODY NO. 3 CONTROL SYSTEM under TROUBLE SHOOTING .
- Check circuits for faults between washer fluid level sensor and body No. 5 ECU. See WIRING DIAGRAMS . Repair or replace as necessary. If circuits are okay, go to next test listed in BODY NO. 3 CONTROL SYSTEM table under TROUBLE SHOOTING .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.