Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Headlight Relay Circuit
NOTE:
If LEXUS scan tool is available, start test from step 1. If this scan tool is not available, start test from step 2.
- Using scan tool, operate headlight relay in ACTIVE TEST. If headlight relay does not operate (headlights do not illuminate), go to next step. If headlight relay operates (headlights illuminate), go to next test listed in BODY NO. 2 CONTROL SYSTEM table under TROUBLE SHOOTING .
- Check headlight relay. See HEADLIGHT RELAY under COMPONENT TESTS. Replace headlight relay as necessary. Retest system operation. If headlight relay is okay, go to next step.
- Check circuits for faults between headlight relay, body control ECU and battery. See WIRING DIAGRAMS . Repair or replace as necessary. If circuits are okay, go to next test listed in BODY NO. 2 CONTROL SYSTEM table under TROUBLE SHOOTING .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
