Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Headlight Cleaner Switch Circuit
Check headlight cleaner switch. See HEADLIGHT CLEANER SWITCH under COMPONENT TESTS. Replace switch as necessary. If switch is okay, check wiring between switch and driver-side junction block ECU. See WIRING DIAGRAMS . Repair or replace as necessary. If circuits are okay, go to BODY NO. 2 CONTROL SYSTEM table under TROUBLE SHOOTING .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.