Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Lexus ES 300FACTORY OEM SERVICE PROCEDURE
Rear Speed Sensor: Removal
- Disconnect speed sensor connector.
- Remove the rear seat cushion and rear seatback.
- Disconnect the speed sensor connector, and pull out the sensor wire harness with the grommet.
- Remove speed sensor.
- Remove the 2 clamp bolts holding the sensor wire harness to the body and shock absorber.
- Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
- Remove the bolt and speed sensor from the axle carrier.
- Torque: 7.8 N.m (80 kgf.cm, 69 in.lbf)
- Remove the 2 clamp bolts holding the sensor wire harness to the body and shock absorber.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
