Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Lexus ES 300FACTORY OEM SERVICE PROCEDURE
Power Window Motor Limit Switch
- Remove door panel. Reconnect window switch. Turn ignition on. Using window switch manual UP mode, close window fully. Using a wire .079" (2 mm) in diameter with a flat end, press reset switch on power window motor. See Fig 1.
- Using window switch manual DOWN mode, open window fully. Remove wire from reset switch. Using window switch manual UP mode, close window fully. Verify proper window operation using window switch AUTO function.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.