2000 Lexus SC 400FACTORY OEM SERVICE PROCEDURE

Shift Control Cable

Loosen swivel nut on transmission shift lever linkage under vehicle. Rotate shift lever on transmission fully to rear. Return lever 2 notches to Neutral position. Set in-car gear selector to "N" position. With gear selector in "N" position, lightly hold lever toward "R" position, and tighten swivel nut on transmission shift lever.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.