Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lexus SC 400FACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Intermediate Shaft-To-Control Shaft Bolt | 26 (35) | ||
| Intermediate Shaft-To-Steering Column Assembly Bolt | 26 (35) | ||
| Sliding Yoke-To-Main Shaft Bolt | 26 (35) | ||
| Steering Column Assembly Nut | 19 (25) | ||
| Steering Wheel Nut | 26 (35) | ||
| Telescopic Adjusting Screw Lock Nut | (1) 19 (25) | ||
| Tilt Steering Housing Support Bolt | 9 (13) | ||
| INCH Lbs. (N.m) | |||
| Connector Bracket Bolt | 43 (4.9) | ||
| Steering Wheel Pad Torx Screw | 80 (9) | ||
| Support Stopper Bolt Adjusting Nut | 27 (3) | ||
| Telescopic Adjusting Screw | 61 (6.9) | ||
| Telescopic Sensor Plate Bolt | 43 (4.9) | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.