Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lexus SC 400FACTORY OEM SERVICE PROCEDURE
Variable Valve Timing Sensor: GS400
- Variable Valve Timing (VVT) sensors are located on top of engine and are mounted on the intake side of each cylinder head. To access left VVT sensor, remove engine cover. Disconnect engine wire protector from upper intake manifold and camshaft bearing cap. Disconnect VVT sensor 2-pin connector with Green and Red wires. To access right VVT sensor, remove engine cover. Remove intake air connector pipe. Disconnect VVT sensor 2-pin connector with Yellow and Blue wires.
- Measure resistance between VVT sensor terminals. Replace sensor if resistance is not as specified. See VARIABLE VALVE TIMING SENSOR RESISTANCE table.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.